5 Steps To Replace a Broken Dryer Drum Belt

5 Steps To Replace a Broken Dryer Drum Belt

A broken drum belt can stop your dryer from spinning, leaving you with damp laundry and frustration. Thankfully, replacing a dryer drum belt is a straightforward repair that you can do with some basic tools and a little patience. Here’s a step-by-step guide to help you get your dryer running again.

1. Gather Your Tools and Supplies

Before you begin, ensure you have everything you need:

  • Replacement Drum Belt: Check your dryer’s model number to find the correct belt.
  • Tools: Screwdriver, putty knife, and possibly a nut driver or socket wrench.
  • Safety Gear: Work gloves and safety goggles.

Pro Tip: Purchase high-quality replacement belts from a trusted supplier like PRS Parts Inc. to ensure durability and compatibility.

2. Disconnect Power for Safety

Unplug the dryer from the electrical outlet or shut off the circuit breaker to prevent accidental shocks. If your dryer is gas-powered, turn off the gas supply valve as well.

3. Access the Drum Belt

  1. Open the Dryer Cabinet:
    • Use a screwdriver or putty knife to remove screws and release clips securing the top panel. Lift it to access the interior.
    • Depending on your dryer model, you may need to remove the front panel as well.
  2. Locate the Drum Belt:
    • The belt is typically wrapped around the drum, motor pulley, and idler pulley. If broken, it may already be loose or out of position.

4. Install the New Belt

  1. Position the Belt on the Drum:
    • Slide the new belt around the drum, ensuring it aligns with the existing grooves or wear marks.
  2. Thread the Belt Around the Pulleys:
    • Route the belt through the idler pulley and around the motor pulley. The idler pulley applies tension to keep the belt tight.
  3. Check Alignment:
    • Ensure the belt is properly seated in the pulleys and grooves to prevent slipping or misalignment.

5. Reassemble and Test

  1. Reattach the Panels:
    • Secure the front and top panels with screws and clips.
  2. Reconnect Power and Test:
    • Plug in the dryer and run a test cycle to confirm the drum spins properly.
  3. Inspect for Issues:
    • Listen for unusual noises and check that the drum spins smoothly.

Get Your Replacement Belt at PRS Parts Inc.

If you need a replacement belt, PRS Parts Inc. in Honolulu, Hawaii, is your one-stop shop. They offer:

  • Wide Selection: High-quality drum belts for all major dryer brands.
  • Expert Guidance: Their knowledgeable team can help you find the right part for your model.
  • Fast Service: Local availability means you can get the parts you need without delay.

Replacing a broken dryer drum belt is a simple repair that can save you time and money. With the right tools, a little effort, and quality parts from PRS Parts Inc., you’ll have your dryer working like new in no time

Back to blog